Specifications
- Dimensions (LxWxH) 85 x 65 x 12 mm
- Voltage supply 3.3 V
- Freely configurable
- Modules are PNO-certified and 100 % tested
- Pin-out compatible to other COM versions
- ERNI SMC plug-in connection to the application (32 Pins)
- Bus and application up to 1.5 kV galvanically separated
- Low power consumption
- LEDs on the circuit board
- 2 x RJ45 plug
- CDI service interface (config, debug, status)
- Parameter changes during operation are possible
Application Interface As Required Via:
- Dual port RAM interface
- SSC shift register interface
- Automatic shift register recognition
- Automatic Baud rate recognition
- Function check possible during operation
- SDI Modbus RTU interface to the application
- Access to all functions
- RS485/ RS232/ UART
- Protocollscripter
- Automatic Baud rate recognition
Environmental Conditions
- Operating temperature: 0°C to +60°C
- Storage temperature: -30°C to +85°C
- Humidity: 0% to 95%, non-condensing
- Condensing: not allowed
- Mechanical shock load: 15G
- Permanent mechanical stress: 5G
- The Module-COM communication interfaces were created by further development of the Module-IC family. With the PROFINET COM module (PROFINET device, PROFINET IRT) from Module, you receive a complete communication interface (piggyback card, option card) with all required components.
- Your application is connected with an SMC plug (32 pins). The interface card also includes all plug-in connectors for the bus connection, but also the optoelectronic couplers, bus drivers, microcontrollers, and memory. The PROFINET module is connected to your application simply by plugging it onto the control card or by means of a cable. Because of the uniform pin-out of all COM modules, they can be replaced easily by other variants (for example EtherCAT, Ethernet/IP, etc.).
